#HOW TO INSTALL TOILET BOLTS TO TANK FULL#

These tools include:Д«esides these tools, you will also need some materials. YouвЂ™ll want to gather all of your tools from the beginning. Tools and Preparations NeededД«e prepared with the necessary equipment before you start the job.

#HOW TO INSTALL TOILET BOLTS TO TANK FULL#

Please take a look at our full toilet measuring guide. However, if you are limited on space, consider going for a round bowl, which takes up less room and will be more likely to fit in a smaller space.

Most toilet bowls are elongated for the sake of comfort.

Toilet Bowl Shape: YouвЂ™ll also want to pay attention to the shape of the bowl of your new toilet.

We recommend that you measure from the bowl to the wall or any other appliances on either side of the toilet, to make sure the toilet will fit in the available space.

Space Around the Toilet: Another factor to consider is the available space for the toilet within your bathroom.

Particularly for toilets with a broader base, itвЂ™ll be helpful to confirm how much room you have besides the water supply line on the floor to make sure the new toilet will fit. Keep in mind any water supply lines as well.

Be sure to measure from the wall and not the baseboard.

Toilet Dimensions (sourced from manual): Beyond the rough-in, youвЂ™ll want to measure all the key specs for your old toilet.

If you select a toilet whose rough-in doesnвЂ™t match the size in your bathroom, the pipes wonвЂ™t match up and you wonвЂ™t be able to install the new toilet. In most cases, the waste pipe measures roughly 12-inches from the wall, but some can measure between 10 and 14-inches.

Rough-In: Make sure you know the rough-in measurement of your old toilet unit.

There are 4 main measurements youвЂ™ll want to be sure of before purchasing your new toilet. Otherwise, you risk buying a new toilet that wonвЂ™t fit in your bathroom.

Installing a New Toilet вЂ“ Step-by-Step GuideДЄs you shop for a new toilet, there are a few different measurements to take into consideration.

In case it's not obvious, I'm just a home DIY'er I purchased the Eco Drakes probably 10 years ago after reading recommendations on this forum - one of the best decisions I've made in that time. Taking a dremel tool to the wing nuts may be a future project!ДЄny thoughts or concerns with the silver bolts? Or tips for better addressing the tight clearance for the water inlet line? As a temporary workaround I connect the water line directly to the tank, positioning the wings so that they did not contact the bowl, and then did the final placement of the tank on the bowl. The tank is operating great, and certainly looks good - but, upon installation I discovered that with the new tank the more squared off shape brings the water inlet pipe so close to the bowl that the plastic wing nuts for the water inlet line hit the bowl. Is that standard with these new tanks? I have a query in to Toto, but have not received a reply yet. the brass bolts that were with the original tank. The parts with the new tank included two silver bolts vs.

Needing the toilet to be operational, I installed the new tank and it fit well (in general) as expected. From a search of the Ferguson site, I see the ST776EA is listed as a replacement for the ST743E. Nothing was available locally, so I ordered online. Not wanting to take a chance on a failure in the middle of the night, I opted to order a replacement tank, a ST743E#01. One of our Eco Drake toilets developed a leak from the original tank and upon inspection I found a couple of what appeared to be small hairline cracks on the bottom of the inside of the tank.

How to install toilet bolts to tank